產品型號：產品名稱：船用油水分離性測定器（JSH4401）產品說明：JSH4401船用油水分離性測定器一、符合SH/T0619標準二、主要技術參數：控溫方式：進口數顯溫控儀自動控溫控溫范圍：常溫~18℃控溫精度：±0

詳細介紹

產品型號：

產品名稱：船用油水分離性測定器（JSH4401）

產品說明：

JSH4401船用油水分離性測定器

一、符合SH/T0619標準

二、主要技術參數：

控溫方式：進口數顯溫控儀自動控溫

控溫范圍：常溫~18℃

控溫精度：±0.5℃

試驗孔數：3孔

試樣攪拌：3600±100r/min可調（數顯計速）

計時方式：數顯時間計時器

工作電源：AC220V±10% 50Hz

功率：2 KW

外形尺寸：400×470×840＝長×寬×高（mm）

整機重量：28Kg

三、性能及特點：

1、本儀器采用進口溫控儀自動控溫，顯示直觀清晰，可滿足18℃±2℃的溫度需求，控溫準確；

2、本儀器采用電熱管加熱和壓縮機致冷，控溫精度高，使用壽命長；

3、攪拌器馬達的轉速從3600±100r/min無級調速，采用傳感器自動檢測電機轉速，并用數顯表顯示，轉速穩定，直觀；

4、本儀器采用數顯計時器計時，到時自動報警，自動停止攪拌；

5、本儀器采用升降電機自動升降攪拌器。

6、本儀器在工作時可同時插入三支離心管，當一支攪完后，可旋轉攪拌頭圓盤，讓電機攪拌第二支離心管內的試樣，完后同樣再攪拌第三支離心管內的試樣

JSH4401 Marine oil-water separation tester

I. It conforms to SH/T0619 standard

Ii. Main Technical parameters:

Temperature control mode: Automatic temperature control with imported digital display temperature controller

Temperature control range: normal temperature ~18℃

Temperature control accuracy: ±0.5℃

Number of test holes: 3

Sample mixing: 3600±100r/min Adjustable (digital display speedometer)

Timing: Digital display time timer

Power supply: AC220V±10% 50Hz

Power rate: 2 KW

External dimension: 400×470×840 = Length × width × height (mm)

Machine weight: 28Kg

Iii. Performance and Characteristics:

1. The instrument adopts imported temperature controller to automatically control temperature, and the display is intuitive and clear, which can meet the temperature demａnd of 18℃±2℃ and the temperature control is accurate;

2. The instrument adopts electric heat pipe heating and compressor cooling, with high temperature control accuracy and long service life;

3. The speed of the agitator motor is stepless regulated from 3600±100r/min. The speed of the motor is automatically detected by the sensor and displayed by the digital display table.

4. The instrument adopts digital display timer to time it, which will automatically alarm and stop stirring;

5. This instrument adopts lifting motor and automatic lifting agitator.

6. Three centrifuge tubes can be inserted at the same time when the instrument is in operation. After one tube is stirred, the agitator head disk can be rotated so that the motor can stir the samples in the second tube, and then the samples in the third tube can be stirred again

關鍵詞：壓縮機 攪拌器傳感器