污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
中國·高能閥門集團騰達閥門有限公司
中國·高能閥門集團騰達閥門有限公司
| 參 考 價 | 面議 |
產品型號
品 牌
廠商性質生產商
所 在 地溫州市
聯系方式：銷售查看聯系方式
更新時間：2024-11-19 09:49:40瀏覽次數：15次
聯系我時，請告知來自 環保在線用途User該閥用于高層建筑消防系統中
用途 User 該閥用于高層建筑消防系統中。當給水管路中壓力超過泄壓設定壓力，泄壓閥開啟，防止管線及設備因超壓而損壞；壓力降至設定值時，該閥自動關閉。 The valve is used in high - rise building fire protection system. When the pressure in the feed line exceeds the pressure of pressure release, the relief valve is opened to prevent the pipeline and equipment from being damaged by overpressure. When pressure drops to a set value, the valve shuts off automatically. 特點 Characteristic 閥體采用全通道流線型設計，流體阻力小，流量大。該閥既可做泄壓閥又可做持壓閥，做泄壓閥時可將給水管中超過導閥安全設定值之壓力釋放，并維持管中壓力于安全值之下，以防止水壓過高造成系統危險；做持壓閥時可維持主閥上游供水壓力于某一設定值以上，只有上游壓力高于設定值時，才向下游供水，以保證主閥上游供水壓力。 Valve body adopts full channel streamline design with small fluid resistance and large flow. Can do pressure relief valve and the valve can be used as a pressure valve, when doing relief valve in the feed pipe can be more than pilot valve value for pressure release, and maintain the pressure in pipe under the TVC, in order to prevent the excessively high hydraulic pressure system risk; When holding the pressure valve, the upstream water supply pressure of the main valve can be maintained above a certain set value, only upstream pressure is higher than the set value, to supply water downstream to ensure the upstream water supply pressure of the main valve. 原理 Principle 主閥的進口側通過控制管與導閥相連，當進口側壓力大于導閥設定壓力時，導閥打開、泄掉膜片上腔的壓力，主閥瓣隨之打開。主閥泄壓，壓力降低至設定壓力時，導閥關閉，主閥也關閉。 The inlet side of the main valve is connected to the guide valve through the control tube. When the inlet side pressure is greater than the guide valve setting pressure,the guide valve opens and release the pressure of the cavity on the diaphragm, and the main disc opens. Main valve release pressure, pressure drop to set pressure,guide valve close, main valve also close. 執行標準 Executive standard 法蘭尺寸 Flange dimensions：GB/T 17241.6 試驗檢驗 Test test：GB/T 13927 安裝圖典型 Installation diagram
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
