当着夫的面被夫上司玩弄,最近免费中文字幕中文高清百度 ,超碰CAOPORON入口,精品国产日韩一区二区三区

行業產品

  • 行業產品

北京杰瑞恒達科技有限公司

空氣微生物采樣器

當前位置:北京杰瑞恒達科技有限公司>>實驗室檢測>>* 細菌計數板

* 細菌計數板

返回列表頁
參  考  價面議
具體成交價以合同協議為準

產品型號HD-825

品       牌

廠商性質生產商

所  在  地北京市

聯系方式:王慧查看聯系方式

更新時間:2017-06-06 21:17:59瀏覽次數:350次

聯系我時,請告知來自 環保在線

經營模式:生產廠家

商鋪產品:102條

所在地區:北京北京市

聯系人:王慧 (銷售)

產品簡介

產品名稱:細菌計數板
規格型號:HD-825

詳細介紹


產品名稱:細菌計數板 
規格型號:HD-825

:

Bacteria Counting Chamber is a one piece construction ensuring durability and accuracy with a Thoma ruling on a single round plateau. The Bacteria Counting Chamber is used for bacteria and sperm counting. Cell Depth is 0.02mm. Usage Bacteria/Sperm Counts Cell Depth 0.02mm +/- 1% (1/50mm) Volume of 1 Square mm 0.02 Microliter Ruling Pattern Thoma, 1/400 Square mm Rhodium coated (bright-line) No Counting Technique : Thoma Counting assumes precise knowledge of the limit lines of the counting chambers used. These are shown in the illustration below. Each one of the small squares is 0.05 x 0.05 mm square, ie 1/400 mm2. This figure will be found printed onto the surface of the counting chamber. To ensure that cells which are on or along the limit lines are not counted twice or are not missed during the count, certain rules have to be observed (see illustration below – this illustration is for an Improved Neubauer, hence the triple lines, but the principle is the same for the Thoma).

The black cells are the ones which would be included in the count for that square, the white ones would not as they will be included in the count for the adjacent squares. The count should be started at the top left-hand corner and follow the direction shown by the arrow (see illustration). Counting may be enhanced with the microscopes illumination reduced.

Notes on Counting Use reduced microscope illumination for all chambers.
The difference of the counter cells in the large squares and the group squares must not exceed 10 cells. Double checks must be performed for all cell counts. After
counting the two counting nets the bottom counting net is to be counted in the same way as a check. When doing this it is to be ensured that the chamber has not dried out. This can be prevented by filling the bottom chamber only shortly before the count and not counting after the sedimentation time.
   The difference between the totals of the counts for the two counting nets must not exceed 10 cells. The average value of the counts is then used in the calculation formula or multiplied by the corresponding factor.

計數板的使用

準備
準備計數時,磨光的表面小心地用擦鏡紙擦干凈。蓋玻片也要擦干凈。

蓋上蓋玻片在需要蓋的周邊區域需要用蒸餾水弄的微濕然后蓋玻片要慢慢的從計數板的前端推入,直到蓋玻片的前端邊緣與計數板的劃格子的區域處于同位。

注意:蓋玻片是很容易壞掉的!

在外部支持和蓋玻片之間的干擾線(牛頓環)的組成顯示了蓋玻片的準確位置。

計數板加樣

取一個良好混合型的吸管并且放置一些初期的幾滴液體。

把吸管的外部擦干然后保持吸管一定的角度直到小滴液體被吸管*吸上去。然后這滴液體被放置在蓋玻片和計數板之間。由于蓋玻片和計數板之間的毛細管現象作用的結果,兩個平面之間的縫隙被灌滿。在溶液要滿出擊數板截面的邊緣之前,馬上移走吸管的*。如果有可見氣泡或者液體已經滿出邊緣并且進入其他的溝里,那么計數板就要擦干凈并且重新加樣。

計數

裝載好的計數板被放置在顯微鏡臺上然后計數格在低倍鏡焦距中顯示。高倍物鏡要非常小心的操作,因為計數板比常規的要更厚。如果你不小心的話,會導致計數板或者物鏡鏡頭的損傷。

如果可能的話,在作血細胞計數的時候使用機械平臺的顯微鏡。顯微鏡的照明是重要的,太亮了會影響劃格線的觀察。光可以通過虹膜光圈減弱直到劃得格子在背景中再次清晰可見。細胞/質粒的計數應該充分稀釋到他們不再互相重疊,并且均勻的分配。

要完成計數檢測需要擴大到期望的可見的細胞/質粒。細胞數量的計算*計數100方格作為排除少量的結果。

計數格在超過劃線區域使用時需要均勻的分配,并且這個通過藉由三倍之?dāng)?shù)決定的方格支架在進入?yún)^(qū)段之內。

計數完100方格后總數除100(計數的方格數),來得到每格的平均值。乘稀釋度,除1/4000(每個小方格的立方容積1/20 x 1/20 x 1/10 – 1/4000mm3)。這次計算得到的數字是原非稀釋流質的每立方毫米的細胞數量。

 

關鍵詞:顯微鏡
其他推薦產品更多>>

感興趣的產品PRODUCTS YOU ARE INTERESTED IN

環保在線 設計制作,未經允許翻錄必究 .? ? ? Copyright(C)?2021 http://www.yixinui.com,All rights reserved.

以上信息由企業自行提供,信息內容的真實性、準確性和合法性由相關企業負責,環保在線對此不承擔任何保證責任。 溫馨提示:為規避購買風險,建議您在購買產品前務必確認供應商資質及產品質量。

會員登錄

×

請輸入賬號

請輸入密碼

=

請輸驗證碼

收藏該商鋪

登錄 后再收藏

提示

您的留言已提交成功!我們將在第一時間回復您~
三台县| 千阳县| 商洛市| 漯河市| 温宿县| 固安县| 肇东市| 增城市| 永平县| 延庆县| 成安县| 德清县| 高安市| 建阳市| 卓资县| 迁安市| 凯里市| 常德市| 湖口县| 中阳县| 格尔木市| 北海市| 青浦区| 区。| 嘉定区| 应用必备| 建始县| 水富县| 江源县| 保康县| 民丰县| 武川县| 郎溪县| 门源| 交口县| 晋州市| 新绛县| 渭南市| 萨嘎县| 新安县| 乐清市|